By using the Aculab site, you agree with our use of cookies.

FAQs in category: Firmware

CIC configuration (CIC base, CIC map, circuit map)

Firmware Non-cloud SS7

How do I configure the register signalling and/or line signalling under CAS?

CAS Firmware Non-cloud

How do I perform point code conversion for SS7?

Firmware Non-cloud SS7

How do you configure the stack configuration file?

Firmware Non-cloud SS7

How should I configure SS7 from v6.2 onwards?

Firmware Non-cloud SS7

I can make CAS calls successfully, but why don't I see any protocol trace when using v6trace?

CAS Firmware Non-cloud

Is it possible to omit any of the switch parameters when setting up SS7?

Firmware Non-cloud SS7

Layer 2 never becomes active even when Layer 1 is working when using CAS.

CAS Firmware Non-cloud

What are point codes in SS7?

Firmware Non-cloud SS7

What is decadic line signalling in the CAS protocols?

CAS Firmware Non-cloud

What is the difference between line signalling and register signalling when using CAS protocols?

CAS Firmware Non-cloud

What protocol firmware file should I download?

Firmware Non-cloud

When would I need an external resource to generate DDI and/or CLI digits while using CAS?

CAS Firmware Non-cloud

Why can't I download network side firmware for any of the following protocols: ETS300, NI2, ATT-E1?

Firmware Non-cloud

Why does the firmware download report the error '-21 ERR_DNLD_BADTLS driver does not support the firmware when using SS7'?

Firmware Non-cloud SS7

Contact Aculab

+44 (0) 1908 273800 (UK)
+1 (781) 352 3550 (USA)

This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.
This email address is being protected from spambots. You need JavaScript enabled to view it.